Avaya Configuring BayStack Remote Access Manual de usuario Pagina 126

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 168
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 125
Configuring BayStack Remote Access
B-2 117341-A Rev. A
Router Fails to Get IP Address
If a message at the BayStack router console indicates that the router failed to get
an IP address from the upstream router, or that the upstream router is unable to
receive BootP requests, ensure that the network cable between the BayStack
router’s synchronous port and the upstream router is firmly connected. Then, refer
to the instructions in one of the following sections to find and correct the problem:
Upstream Router Not Receiving BootP Requests
Upstream Router Not Sending BootP Responses
If you follow the instructions in these sections and cannot find and correct the
problem, contact the Bay Networks Technical Solutions Center.
Upstream Router Not Receiving BootP Requests
If the upstream router is not receiving BootP requests, use the
getcfg command to
display the router parameters and the
bconfig and ifconfig commands to correct
them, if necessary. See “Displa
ying Parameter Settings” on page B-10 and
De
bugging the BootP Server” on page B-12 for instructions.
Upstream Router Not Sending BootP Responses
If the upstream router is receiving BootP requests but is failing to send BootP
responses, use Site Manager to verify the following:
The upstream router’s interface to the BayStack router is enabled.
BootP is enabled on the circuit connecting the BayStack router to the
upstream router.
The upstream router’s link modules and drivers are loaded.
IP is enabled on the upstream router.
BootP is enabled on the upstream router.
The BootP relay agent forwarding table associated with the upstream router
shows an IP address that is configured on the IP router.
The input IP address is correct.
If you are using EZ-Install over a Frame Relay PVC in group access mode,
the upstream router’s BootP client interface table is configured properly.
Vista de pagina 125
1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 167 168

Comentarios a estos manuales

Sin comentarios