
DS1E1 Events
3-107
Entity Code/Event Code 63/88
Decimal Identifier 16793432
Severity: Warning
Message: Module <module_no.>, Framer CoProcessor Command Ring found FULL at 0x%03x.
Meaning: The Framer CoProcessor's command ring overflowed. Information was lost between the
host and the Framer Coprocessor. This indicates a software problem which must be fixed.
Action: Report this problem to the Bay Networks Technical Response Center.
Entity Code/Event Code 63/90
Decimal Identifier 16793434
Severity: Warning
Message: Module <connector_no.> aborting init. No Module Present in this Module location.
Meaning: For the ASN, MCE1 and MCT1 Net Module, a configured module is not present.
Action: Install the module or remove its configuration.
Entity Code/Event Code 63/91
Decimal Identifier 16793435
Severity: Warning.
Message: Module <connector_no.> aborting init. Wrong Module type in this Module location.
Meaning: For the ASN, MCE1 and MCT1 Net Module, although this DS1E1 module is configured,
the installed Module is not the correct type.
Action: Check the type and configuration of the module.
Entity Code/Event Code 63/92
Decimal Identifier 16793436
Severity: Warning
Message: Module <connector_no.> aborting init. Diag failed (status=0x%x ).
Meaning: For the ASN, MCE1 and MCT1 Net Module, diagnostics indicate a failed status for this
DS1E1 module.
Action: The module is bad. Install a new module and verify that it passes diagnostics.
Comentarios a estos manuales