Avaya Configuring WAN Line Services Manual de usuario Pagina 55

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 246
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 54
Configuring Synchronous Services
117021-A Rev. A 2-21
By default, the Cable Type parameter is set to Null. Set the cable type for the
interface.
Setting the Retry Timer
By default, the router waits 3 seconds for a response from the interface. When the
timer expires, the router
1. Sends Link Control frames.
2. Resends the frames up to the value of the Retry Count parameter.
3. Disconnects the link.
Set the value of the Retry Timer on the interface to a value from 1 to 9999
seconds.
Enabling or Disabling Extended Addressing
By default, the router does not test the address length of frames on a synchronous
interface. With the Extended Address parameter enabled, the router tests the first
bit of the address to determine the length of the address, in octets.
Enable or disable extended addressing for the interface.
Enabling or Disabling Remote Loopback Detection
You can configure the router to automatically disable a synchronous interface
upon detecting its own BofL messages by enabling the Remote Loopback
Detection on an interface. If BofL is enabled, the device driver disables the
interface upon receiving its own BofL packets, assuming that the link has been put
into loopback mode. This function is disabled by default.
Site Manager: Cable Type parameter: page A-54
Site Manager: Retry Timer parameter: page A-46
Site Manager: Extended Address parameter: page A-47
Vista de pagina 54
1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 245 246

Comentarios a estos manuales

Sin comentarios