
Configuring WAN Line Services
A-56 117021-A Rev. A
Parameter: Sync Hold Down Time
Path: COM Connector > Edit Line > Edit Sync Parameters
Default: 0 seconds
Options: 0 to 9999 seconds
Function: Specifies a time period for the router to wait before bringing up this line when
using dial services. This delay allows time for the primary line to recover,
before deactivating a backup line.
Instructions: Enter the number of seconds to wait before bringing up this line.
MIB Object ID: 1.3.6.1.4.1.18.3.4.5.1.80
Parameter: Network Link Level
Path: COM Connector > Edit Line > Edit Sync Parameters
Default: NET2
Options: NET2
| GOSIP | SYNC_TYPE_C03
Function: Indicates the link level for this synchronous point-to-point connection.
Instructions: Accept the default, NET2 for most configurations, or:
• Change to GOSIP when this synchronous point-to-point connection is part of
a GOSIP-compliant network (such as DOD).
• Change to SYNC_TYPE_C03 when you are running X.25 on the QSync,
DST, or ESAF synchronous link modules.
MIB Object ID: 1.3.6.1.4.1.18.3.4.5.1.81
Parameter: Cable Type
Path: COM Connector > Edit Line > Edit Sync Parameters
Default: Null
Options: Null
| RS232 | RS422 | V35 | X21
Function: Specifies the cable interface to the network.
Instructions: When the interface connects to a dialup device for switched services, set this
parameter to reflect the cable interface type that connects the dial unit. For an
SDLC interface, set to RS232.
MIB Object ID: 1.3.6.1.4.1.18.3.4.5.1.83
Comentarios a estos manuales