Avaya SIP Software 3.2 for 1200 Series Manual de usuario descargar pdf (Pagina 71)

IP Deskphone configuration file is updated, configure FORCE_REBOOT YES in the

device configuration file.

• AUTOLOGIN_PASSWD_KEY01

This parameter is located within the IP Deskphone-specific configuration file. There is no

default password. If this is blank and AUTOLOGIN_ENABLE is configured to

USE_AUTOLOGIN_ID (or 2) in the device configuration file, the IP Deskphone does not

log on.

Note:

To provision AUTOLOGIN_PASSWD_KEY01, the IP Deskphone must be rebooted

after the IP Deskphone configuration file is updated. To force a hard reboot after the

IP Deskphone configuration file is updated, configure FORCE_REBOOT YES in the

device configuration file.

Create the Dialing Plan file on the provisioning server

A dialing plan essentially describes the number and pattern of digits that a user dials to reach

a particular telephone number. Access codes, area codes, specialized codes, and

combinations of the number of digits dialed are all part of a dialing plan.

The purpose of the dialing plan is so that the end user does not have to press the send or

pound key (#) to have the IP Deskphone with SIP Software send the initial message to start

the call.

Dialing a telephone number on an IP Deskphone that supports SIP can be different than dialing

a number from a traditional telephone. SIP signaling is communicated through a SIP URI to

get to the far end. For example, you can key in the SIP address, jsmith@yourcompany.com to

reach John Smith. When the IP Deskphone with SIP Software receives this address, the dialing

plan is bypassed and the IP Deskphone uses the SIP URI to send a SIP INVITE to

jsmith@yourcompany.com (INVITE sip: jsmith@yourcompany.com).

Entering a SIP URI address, however, is inconvenient for an IP Deskphone with SIP Software.

Also, the user must explicitly press the send key (or use some method to indicate the end of

the URI) to indicate the completion of the SIP address. This is not something that the user is

accustomed to in a traditional PBX environment.

The alternative is to use a URI where numbers are used to reach the far end. Using different

access codes, the IP Deskphone with SIP Software translates the digits entered into something

that the server can understand and remaps the number entered into different URIs. Some of

the numbers are mapped as intercom calls, some numbers are mapped as local Public

Switched Telephone Network (PSTN) calls, and some numbers are mapped as public long-

distance calls.

The issue is that until the IP Deskphone itself can determine the type of call, no SIP INVITE

message is sent. This is where the dialing plan comes into effect. The call type is determined

by the dialing plan. Based on the rules defined in the dialing plan, once a match has been

Create the Dialing Plan file on the provisioning server

SIP Software for Avaya 1200 Series IP Deskphones-Administration January 2012 71

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 319 320

Sin comentarios

Avaya SIP Software 3.2 for 1200 Series Manual de usuario Pagina 71