
Ntwk Port Duplex
There are three options available to provision the Network Port Duplex for Network Port Speed
of 10BT or 100BT.
• Auto – duplex is autonegotiated. Avaya recommends that Auto Negotiate mode is used
on the network and the IP Deskphone.
• Force Full – duplex is forced to FULL. Use Force Full mode only when the network is
forced Full Duplex. Otherwise a duplex mismatch results.
• Force Half – duplex is forced to HALF. Use Force Half mode only when the network is
forced Half Duplex. Otherwise a duplex mismatch results.
Disable Voice 802.1Q
If 802.1Q is disabled, standard Ethernet frames are transmitted. If 802.1Q is enabled, all frames
transmitted by the Ethernet driver have the 802.1Q tag bytes inserted between the source MAC
address and the protocol type field.
Voice VLAN
Configure the Voice VLAN.
Table 15: Telephony Port (incoming)
Voice VLAN Setting Result
No VLAN (default setting) All telephony traffic that is transmitted on the
telephony port is forwarded untagged.
Manual (value from 1 to 4094) All telephony traffic that is transmitted on the
telephony port has an 802.1q header
appended and its Voice VLAN ID is set to the
value manually configured here.
Enter a value from 1 to 4094.
Ntwk Port Duplex
SIP Software for Avaya 1200 Series IP Deskphones-Administration January 2012 111
Comentarios a estos manuales