
Local Boot: The Quick-Start Procedure
114074 Rev. A B-13
6. Follow the script online, using your worksheets for responses to its
prompts.
Refer to the list of Quick-Start commands in
Table B-1.
The 100BASE-T Hub progresses through the Quick-Start script as follows:
a. The Quick-Start script begins prompting for the initial Global
Worksheet information.
b. The script prompts for specific protocol information.
c. The script requests a wide-area protocol selection.
d. The script prompts for specific protocol information.
e. The script prompts for the rest of the Global Worksheet information.
f. After you enter all of the Global Worksheet protocol information, the
Quick-Start script displays a Configuration Summary and prompts
you to save the configuration to a file.
7. Name and save the configuration file.
The script begins to test the configuration on the new IP interface
(Figure B-1).
Table B-1. Quick-Start Commands
To Do the Following Action Details
Accept a default value Press Return Your console displays default values in
brackets; for example, [E11].
Repeat a step (for
example, if you make a
mistake)
Press Control-c
Press n
When prompted, “Terminate script y/n?”
press the n key. You return to the
beginning of the step so you can
re-enter the information.
Stop the Quick-Start
installation procedure
Press Control-c
Press y
When prompted, “Terminate script y/n?”
press the y key. The Quick-Start
procedure is terminated and you return
to the Technician Interface prompt.
To restart the Quick-Start procedure,
you must reboot the router by entering
boot and pressing the Return key.
Comentarios a estos manuales