
Applying Inbound Traffic Filters
117348-A Rev. A 6-3
Figure 6-1. Inbound Traffic Filters Window
Preparing Inbound Traffic Filter Templates
To add an inbound traffic filter to a router interface, you apply a protocol-specific
traffic filter template to the circuit. However, you do not always need to create a
template; often, you can begin with an existing template. This section describes
how to prepare an inbound traffic filter template by:
• Cr
eating a Template
• Customizing Templates
See “Cr
eating an Inbound Traffic Filter” later in this chapter to learn how to create
the filter by applying (saving) a filter template to an interface.
Comentarios a estos manuales