Avaya Configuring Traffic Filters and Protocol Prioritization Manual de usuario Pagina 150

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 162
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 149
Configuring Traffic Filters and Protocol Prioritization
B-10 117348-A Rev. A
Place RIP traffic
in the Low queue
Criteria > Add > IP > IP >
UDP Destination Port
520 Action > IP > Add
> Low Queue
See Table 5-7 in
Chapter
5 for a list of
common UDP port
codes.
Place OSPF
traffic in the High
queue
Criteria > Add > IP > IP >
Protocol Type
89 Action > IP > Add
> High Queue
See T
able 5-9 in
Chapter
5 for a list of
common IP Protocol
and Type codes.
Place
OSPF/BGP traffic
in the High queue
Criteria > Add > IP > IP >
Type of Service
0xE0 Action > IP > Add
> High Queue
Place Spanning
Tree Protocol
(STP) traffic in
the High queue
Criteria > Add > Datalink
> Source Routing >
DSAP | SSAP | Control
0x42 (DSAP
or SSAP)
0x03 (Control
code)
Action > Datalink >
Add > High Queue
See T
able 5-3 in
Chapter
5 for a list of
SAP codes.
Place
synchronous
pass-through
traffic in the High
queue
Criteria > Add > Datalink
> 802.2 SNAP Ethernet
0x80FF Action > Datalink >
Add > High Queue
Prioritize FTP,
Telnet, and other
large-packet
data traffic by
placing smaller
packets in the
Low queue
Criteria > Add > IP >
Source Address
Client IP
addresses
Action > IP > Add
> Length
In the Prioritization
Length window,
specify:
Packet Length = 500
bytes
Less Than or Equal
Queue = Low
Greater Than Queue
= High
Table B-3. Sample Criteria, Ranges, and Actions for Protocol Prioritization
(continued)
Filtering Goal Criteria Path Ranges Action Path Notes
Vista de pagina 149
1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 161 162

Comentarios a estos manuales

Sin comentarios