
Configuring Traffic Filters and Protocol Prioritization
7-8 117348-A Rev. A
4. Select High, Low, or Normal as the queue
in which a packet is placed if the length is
less than or equal to the value of Packet
Length.
For example, if Packet Length is set to 1024
bytes, any packet that is 1024 bytes or less is
placed in the queue you selected.
5. Click on OK. The Values Selection window closes. The
Prioritization Length window now displays
the new value.
6. Select the Greater Than Queue field; then,
click on Help for information, or refer to the
description on page
A-8 in Appendix A.
7. Click on Values. The Values Selection window opens.
8. Select High, Low, or Normal as the queue
in which a packet is placed if the length is
greater than the value of Packet Length.
9. Click on OK. The Values Selection window closes. The
Prioritization Length window now displays
the new value.
10.Click on OK. The Create Priority/Outbound Template
window opens, showing the newly
selected criterion, range, and action in
the Filter Information field (Figure
7-4).
11.Click on OK. The Filter Template Management
window opens (Figure 7-3).
Site Manager Procedure
(continued)
You do this System responds
Comentarios a estos manuales