Avaya BCM50 Guía de configuración descargar pdf (Pagina 522)

100

101

522 Chapter 70 Dial Up Interfaces panel

NN40020-603NN40020-603

To add an automatic dial-out interface

1 Create a Modem or ISDN interface. See “To add an ISDN interface” on page 503 or “To add

the modem interface” on page 508.

2 Enable the interface under Configuration > Resources > Dial Up Interfaces.

3 Select the Automatic Dialout check box for the interface.

4 Set the Idle timeout (s) on the Link Parameters tab to a value greater than 60 seconds.

5 Add a static route. Refer to “To add a new IP Static Route” on page 463.

6 Associate the route with an application.

To manually disconnect an auto dial-out interface

1 Click Configuration > Resources > Dial Up Interfaces.

2 Select the interface to disconnect.

3 Click Disconnect.

A confirmation dialog box will appear.

4 Click Yes.

Guidelines for using remote Dial-in

Consider the following guidelines when using remote dial-in:

• The remote dial-in for administration and the backup WAN link share the same modem. If a

remote administration user is connected while the primary link breaks, the automatic backup

function does not occur.

• While using the back-up interface, BCM always calls. BCM does not answer an incoming call

from a router on the V.92 interface.

Using a dial-up interface as a primary connection

The dial-up interfaces on the BCM are used as a Primary or Secondary interfaces. The BCM does

not have default dial-up settings, the Administrator must add them.

Note: If an interface is enabled and configured for manual dial-out, the

interface must be disabled before it can be configured for automatic

dial-out.

Note: Auto dial-out interfaces are disconnected automatically once data

transfer is complete.

1 2 ... 517 518 519 520 521 522 523 524 525 526 527 ... 567 568

Comentarios a estos manuales

Sin comentarios

Avaya BCM50 Guía de configuración Pagina 522

Comentarios a estos manuales

Relacionado con productos y manuales para Software Avaya BCM50