Avaya BCM50 Guía de configuración descargar pdf (Pagina 193)

100

101

Chapter 19 BRI ISDN: BRI loop properties 193

Networking Configuration Guide

Table 34 describes each section on the D-Packet Service panel.

S-loops assigned DNs

The Details for Loop panel for S-loops allows you to view which device records are assigned to a

loop, and to add or delete a record from the loop.

Figure 62 illustrates the Details for Loop panel.

Table 34 D-packet settings

Attribute Value Description

Associated loop X01-X04 T-loop: This is the loop on the BRI module that is configured as the

T-loop and is connected to the external trunk.

S-loop: This is the loop on the BRI module where the device is

connected.

Enabled D-packet

Service

<check box> Enable this service, only if you are installing devices that require

this type of service.

TEI <digits> These entries identify up to eight terminal identifiers for the devices

assigned to the S-loops. Your BRI service provider supplies these

numbers, if they are required.

Actions

Add 1. In the top frame, click the loop where you want to define D-Packet Service.

2. In the bottom frame, Ensure Enable D-packet service check box is selected.

3. In the Associated loop field, enter a defined S-loop.

4. Under the TEIs table, click Add.

5. Enter a TEI.

6. Click OK.

7. Repeat for all the TEIs you want to assign.

Delete 1. In the top frame, click the loop where you want to delete TEI assignments.

2. In the bottom frame, click the TEI you want to delete.

3. Click Delete.

4. Click OK.

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 567 568

Comentarios a estos manuales

Sin comentarios

Avaya BCM50 Guía de configuración Pagina 193

Comentarios a estos manuales

Relacionado con productos y manuales para Software Avaya BCM50