Avaya BCM50 Guía de configuración descargar pdf (Pagina 161)

Chapter 14 Configuring lines: T1-Loop start 161

Networking Configuration Guide

Configuring digital (T1/E1) loop start lines

The following procedure describes the fields that need to be confirmed or set for these lines. For

detailed field descriptions, refer to “Configuring lines” on page 129.

To configure digital loop start lines

1 Confirm or change the settings on the Trunk/Line Data main panel:

• Line: Read only list shows available lines for system.

• Trunk Type: Loop.

• Name: Default name is line number, shown as part of incoming CLID.

• Control Set: If you use schedules, enter DN for telephone that controls line schedules.

• Line Type: Define as public, if the line is shared or as Private To (DN) if the line is

assigned to a specific telephone, or put it in a line pool (A to O).

• Prime Set: If you want the line to be answered at another telephone if the line is not

answered at the target telephone, otherwise, choose None.

• Pub. Received #: Not applicable.

• Priv. Received #: Not applicable.

• Distinct Ring: If you want this line to have a special ring, indicate a pattern (2, 3, 4, or

None).

Under the Properties tab:

• Trunk mode: Define whether the line will detect the open switch interval (OSI) when a call

is released (supervised). Note: UK profiles use Loop guarded/Loop unguarded.

• Dial mode: The line service will dictate whether this needs to be set to Pulse or Tone

(DTMF) dialing.

2 Configure the trunk/line data (Preferences tab):

• Auto privacy: If you activate this feature, the line is available only to the telephone that

answers the call.

• Full autohold: This allows telephones to put a line on hold if the user picks up another line

or starts to dial out on another line.

• Aux. ringer: If your system is equipped with an external ringer, you can enable this setting

to allow this line to ring at the external ringer.

• Distinct rings in use: Indicates if a special ring has been assigned.

• Answer mode/Answer with DISA: If this line is used for remote call-ins, determine how

you want the line to answer (automatically, or requiring more user input). If the answer

mode is set to Auto, decide whether the caller will be immediately connected to the system

or whether a stuttered dialtone will require the caller to enter a CoS password.

• Voice Message Center: If the system is using a remote voice mail, select the center

configured with the contact number.

• Redirect to: If you want to automatically direct calls out of the system to a specific

telephone, such as a headoffice answer attendant, enter that remote number here. Ensure

that you include the proper routing information.

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 567 568

Sin comentarios

Avaya BCM50 Guía de configuración Pagina 161