Avaya IP Telephony Guía de configuración Pagina 171
- Pagina / 222
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Silence compression 171
IP Telephony Configuration Guide
When silence compression is enabled, voice packets are only sent when a speaker is talking. When
a voice is being transmitted, it uses the full rate transmission rate. Since the sender and receiver do
not share the same channel, the peak bandwidth requirement per channel is still equal to the full
transmission rate. The following figure shows the peak bandwidth requirements for one call on a
full-duplex link with silence compression enabled. The spare bandwidth made available by silence
compression is used for lower priority data applications that can tolerate increased delay and jitter.
Figure 62 One call on a full duplex link with silence compression
Time ->
Bandwidth ->
Bandwidth Used
Rx
Tx
Fred Here.
Hello Fred. This is Susan. Do you have a minute?
Time ->
Sure!Hi!
Bandwidth ->
Tx ChanRx Chan
Independent Tx and Rx bandwidth not shared by “half-
duplex” call. Bandwidth available for data apps.
Channel Max
Channel Max
Hello Fred. This is Susan.
Do you have a minute?
Fred here.
Hi!
Sure!
Conversation
Bandwidth used
Independent Tx and Rx bandwidth not shared by half-duplex calls.
Bandwidth available for data apps.
Time
Channel/Link max
Tx channel
Bandwidth
Tx
Rx
Channel/Link max
Rx channel
Bandwidth
Time
- Business Communications 1
- Manager 3.6 1
- IP Telephony Configuration 1
- Trademarks 2
- Contents 3
- Chapter 3 4
- Chapter 4 4
- Chapter 5 5
- 10 Contents 10
- P0609327 02 10
- Before you begin 15
- Symbols used in this guide 15
- Text conventions 16
- Acronyms 17
- Related publications 18
- How to get help 19
- 20 Preface 20
- Chapter 1 21
- Introduction 21
- IP telephones and VoIP trunks 22
- Figure 1 Network diagram 24
- Telephones 25
- Gatekeepers on the network 25
- IP network 26
- Key IP telephony concepts 27
- Jitter Buffer 28
- QoS routing 29
- Chapter 2 31
- Prerequisites checklist 31
- Network devices 32
- Network assessment 33
- Resource assessment 33
- Keycodes 34
- Option Description 35
- VoIP trunks 39
- IP telephone records 40
- Installing IP telephones 41
- Choosing a codec 45
- Choosing a Jitter Buffer 46
- Before installing 46
- Using a 3-port switch 46
- Display buttons 48
- Troubleshooting IP telephones 51
- Operation issues 52
- Configuring DHCP 53
- IP telephony DHCP notes 54
- Checking IP server status 56
- Figure 7 IP Terminal status 57
- Notes about Hot Desking 62
- Customizing feature labels 63
- Moving IP telephones 69
- Figure 16 i2050 Switch type 72
- Handset and call functions 74
- Configuring NetVision records 75
- Assigning general settings 76
- Changing a handset Name 82
- Deregistering a telephone 83
- Configuring local VoIP trunks 85
- Published IP address 86
- Counting IP trunks 87
- Configuring media parameters 89
- Setting up the local gateway 91
- How to use target lines 98
- Configuring target lines 99
- Chapter 6 101
- Field Value Description 104
- 6 Click the Save button 105
- Outgoing call configuration 107
- H.323 trunks 108
- SIP trunks 108
- Keycodes: 2 108
- PSTN call to remote node 109
- Call process 110
- Describing a fallback network 113
- Adding routes for fallback 114
- Figure 35 Route XXX screen 115
- Figure 36 VoIP schedule 117
- How fallback routing works 120
- Settings for 124
- Santa Clara 124
- Connecting an i200X telephone 125
- PSTN fallback metrics 126
- Quality of Service Monitor 127
- Updating the QoS monitor data 128
- Chapter 7 129
- 3 Enter the port settings 130
- Modifying PortRanges 131
- Using a gatekeeper 133
- 8 Click Submit 140
- Gatekeeper call scenarios 141
- Faxing over VoIP lines 142
- Chapter 8 147
- WarehouseHead Office 148
- Appendix A 153
- Efficient Networking 153
- Network engineering 154
- LAN engineering examples 157
- WAN engineering 158
- Setting Non-linear processing 159
- Enough link capacity 161
- Further network analysis 162
- Components of delay 163
- Reduce link delay 163
- Reducing hop count 164
- Adjust the jitter buffer size 164
- Reduce packet errors 164
- Routing issues 165
- Appendix B 167
- Silence compression 167
- Time -> 169
- Bandwidth -> 169
- Channel/Link Max 169
- Comfort noise 172
- Appendix C 173
- Network performance utilities 173
- Appendix D 175
- Interoperability 175
- Speech path setup methods 176
- Media path redirection 177
- Gatekeeper 177
- No feedback busy station 178
- Interoperability 179 179
- 180 Interoperability 180
- Using VLAN on the network 181
- 182 Interoperability 182
- Symbol NetVision telephones 183
- 184 Interoperability 184
- Interoperability 185 185
- 186 Interoperability 186
- Interoperability 187 187
- 188 Interoperability 188
- Interoperability 189 189
- 190 Interoperability 190
- Appendix E 191
- Quality of Service 191
- 192 Quality of Service 192
- Measuring Intranet QoS 193
- Recording routes 194
- Adjusting Ping measurements 195
- Measurement procedure 196
- Quality of Service 197 197
- Traffic mix 198
- TCP traffic behavior 199
- Network Quality of Service 200
- Quality of Service parameters 201
- Fallback to PSTN 201
- 202 Quality of Service 202
- Glossary 203
- 204 Glossary 204
- Glossary 205 205
- 206 Glossary 206
- Glossary 207 207
- 208 Glossary 208
- Glossary 209 209
- 210 Glossary 210
- 222 Index 222
Relacionado con productos y manuales para Manuales de software Avaya IP Telephony
Manuales de software Avaya Router Guía de inicio rápido
(132 paginas)
(132 paginas)
Manuales de software Avaya Configuring SNMP, RMON, BOOTP, DHCP, and RARP Services Manual de usuario
(130 paginas)
(130 paginas)
Manuales de software Avaya LT2P Manual de usuario
(76 paginas)
(76 paginas)
Manuales de software Avaya BCM 4.0 Guía de usuario
(42 paginas)
(42 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.028 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales