Avaya Configuring IP Multicasting and Multimedia Services Manual de usuario Pagina 166

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 234
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 165
Configuring IP Multicasting and Multimedia Services
9-16
303527-A Rev. 00
Configuring an AS Boundary Router for Use with IGMP Relay
An IGMP-R device communicates with a router configured as an MOSPF AS
boundary router. To configure a router for use with an IGMP-R device, you must
do the following:
Configure the router as an MOSPF AS boundary router. For information on
OSPSF, see Configuring IP Services. For information on MOSPF, see
Chapter 5
.
Set the MOSPF Multicast Downstream IGMP Relay parameter to Enabled.
For information, see “Configuring Multicast-Capable External Routeson
page 5-11.
Configure RIP globally on the MOSPF boundary router. For information
about RIP, see Configuring IP Services.
Add MOSPF and IGMP to each interface that connects the router to the
multicasting domain.
Add RIP, MOSPF, and IGMP to the downstream interface that connects the
router to the IGMP-R device. Note that MOSPF is configured on the multicast
interface only. As a unicast device, IGMP-R does not run MOSPF or any
other multicast protocol on the upstream interface to the MOSPF boundary
router.
Add RIP to the downstream interface that connects the MOSPF boundary
router with the IGMP-R device.
Vista de pagina 165
1 2 ... 161 162 163 164 165 166 167 168 169 170 171 ... 233 234

Comentarios a estos manuales

Sin comentarios