Avaya Configuring Bridging Services Manual de usuario Pagina 77

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 208
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 76
Using Source Routing Bridge Services
117351-A Rev. A 2-21
Alternatively, you could configure a connectionless IP address on each router
and configure only the connectionless address. This would reduce explorer
traffic but would ensure that the IP address is up.
Source Routing over Frame Relay Networks
The Bay Networks source routing bridge supports source routing over frame relay
networks, using RFC 1490 standard frame relay encapsulation and Bay Networks
proprietary frame relay encapsulation.
To select proprietary or RFC 1490 standard frame relay encapsulation, use the
Encapsulation Format parameter as described in the section “Source Routing
Interface Parameter Descriptions” on pa
ge 2-40.
Source Routing over FDDI
The Bay Networks source routing bridge supports communications between token
ring end stations and FDDI end stations, using standard native encapsulation and
proprietary encapsulation. Use Bay Networks proprietary encapsulation if you
want to communicate with a Version 7 router running source routing over FDDI.
To select proprietary or standard encapsulation, use the Encapsulation Format
parameter as described in the section “Source Routing Interface Parameter
Descriptions” on pa
ge 2-40.
Note: Each IP address on a router that receives an ARE forwards the ARE
through all other source routed interfaces. This can cause duplicate AREs on
the network, but it ensures redundancy if the service of any token ring interface
is interrupted.
Vista de pagina 76
1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 207 208

Comentarios a estos manuales

Sin comentarios