
Configuring Bridging Services
5-6 117351-A Rev. A
Figure 5-2. Edit NML Interface Window
4.
For instructions on editing NML parameters and assigning an access list
to a port, refer to “Editing NML Interf
ace Parameters” on page 5-8 and
“Assigning an
Access List to a Port” on page 5-12.
Editing NML Parameters
Once you configure a circuit to support NML, you can use the Configuration
Manager to edit the NML parameters. This section describes how to edit these
parameters.
For each NML parameter, this section provides information about default settings,
valid parameter options, the parameter function, instructions for setting the
parameter, and the MIB object ID.
Note: The instructions in this section assume that you already configured
NML on the router. If you did not, refer to Configuring and Managing Routers
with Site Manager for details.
Comentarios a estos manuales