Avaya Configuring Bridging Services Manual de usuario Pagina 64

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 208
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 63
Configuring Bridging Services
2-8 117351-A Rev. A
IP Encapsulation Features
Bay Networks implementation of IP encapsulation allows you to:
Configure redundant IP interfaces.
You can configure redundant IP interfaces on the same router for critical
network connections (for example, interfaces 1.1.2.2 and 1.1.3.3 on bridge B).
That way, if you disable one of the interfaces, the other interface can still
accept IP traffic for the network. (When you enable redundant IP interfaces,
you also increase explorer traffic on the network. Therefore, enable redundant
interfaces selectively to reduce the impact on your network performance.)
Expand your IP backbone network.
You can expand your IP backbone to include any Bay Networks IP router on
the network. You specify the router’s IP address in the IP explorer list for each
bridge.
For example, bridge A currently forwards all traffic destined for ring 7 to IP
interface 1.1.3.3. That router then forwards the traffic toward ring 6 so that the
router can source route it to ring 7. If you add IP address 1.1.4.4. to the IP
Explorer list for bridge A, then bridge A forwards all traffic destined for ring 7
directly to IP interface 1.1.4.4. By expanding your IP backbone, the source
routing bridge can route through more stations, but it still can only add a
single hop to a packet’s RIF.
Reduce excess broadcast traffic on your IP network.
You can reduce the number of broadcast and explorer packets that traverse the
network by constructing directed explorer filters. (See Configuring Traffic
Filters and Protocol Prioritization for information on how to create filters
that forward IP explorer frames to specific addresses.)
Configure both IP encapsulation support and source route end station support
on the same interface.
IP encapsulation support works independently of source route end station
support. However, you can enable both on the same circuit.
Vista de pagina 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 207 208

Comentarios a estos manuales

Sin comentarios