Avaya Configuring Bridging Services Manual de usuario Pagina 38

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 208
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 37
Configuring Bridging Services
1-16 117351-A Rev. A
Enabling Spanning Tree on an Interface
To enable spanning tree on an interface:
1. From the Select Protocols menu, select the Spanning Tree option that is
directly under the Bridge option.
Note that the Configuration Manager also selects the Bridge option because
this Spanning Tree protocol cannot run without Bridge enabled.
2. Click on OK.
The Spanning Tree Autoconfiguration window appears (F
igure 1-13).
When you enable spanning tree service, you need only configure the Bridge
Priority and Bridge MAC Address parameters. The Configuration Manager
supplies default values for the remaining parameters. If you want to edit the
default values, see Editing Br
idge Parameters on page 1-18.
3. Configure the parameters, using the descriptions that follow as a guide.
4. When you have configured the required parameters, click on OK.
A window prompts
Do you want to edit the Spanning Tree Interface Details?
5. Click on Cancel to enable default Spanning Tree service and display the
next protocol-specific window, or click on OK to edit the default spanning
tree values.
(See Editing Br
idge Parameterson page 1-18 for instructions.)
Note: Because the spanning tree is global (that is, it runs across all Bridge
circuits), the Configuration Manager only displays the Spanning Tree
Autoconfiguration window the first time you specify Spanning Tree for the
Bridge. If you have previously specified Spanning Tree for source routing, this
window will not appear. To change the parameter settings at a later time, see
the Editing Br
idge Parameters section.
Vista de pagina 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 207 208

Comentarios a estos manuales

Sin comentarios