
BCC show Commands
117351-B Rev. 00
C-7
show srb global
The
show srb global
command displays the state of the source routing bridge and
the values of key source routing attributes.
The output includes the following information:
show srb interface
The show
srb interface command
displays information about each source route
bridge interface on the router.
This command allows for the following command filter (flag) and filter argument:
The output includes the following information:
Srb Setting of the source routing bridge on the router:
Enabled or Disabled.
State State of the source routing bridge on the router: Up,
Down, Init (initializing), or Notpresent.
Internal LAN ID Internal LAN ID of the source routing bridge.
Bridge ID Source routing bridge ID.
Group LAN ID Source routing bridge group LAN ID.
IP Encapsulation State of IP encapsulation: Enabled or Disabled.
-interface
<circuit_name>
Displays information about the specified circuit only.
Circuit Name Name of the source routing bridge circuit.
Source Routing Ring Num Ring number of this source routing bridge circuit.
Ste In Whether or not the source routing bridge drops
inbound STEs on this circuit: Accept or Block.
Ste Out Whether or not the source routing bridge drops
outbound STEs on this circuit: Accept or Block.
Comentarios a estos manuales