Avaya Configuring Bridging Services Manual de usuario descargar pdf (Pagina 202)

Configuring Bridging Services

6-14

117351-B Rev. 00

For example, the following command reenables transparent bridging on an

interface:

bridge/ethernet/2/1# state enabled

Sending a Copy of the Forwarding Table to the Log

You can specify that you want to store a copy of the MAC addresses on the bridge

interface or in the bridge’s forwarding table sent to the router’s log. You may want

a record of the MAC addresses for troubleshooting purposes, for example.

To send a copy of the MAC addresses to the log, navigate to the interface bridge

prompt and enter:

log-mac-address

setting

is one of the following:

local

forward-table

none

The local setting sends the addresses stored locally on the bridge to the log. The

forward-table setting sends the addresses stored in the forwarding table to the log.

After it sends the addresses, the system automatically reverts to the

none setting.

For example, the following command sends a copy of the MAC addresses stored

in the bridge’s forwarding table to the router log:

bridge/ethernet/2/1# log-mac-address forward-table

Customizing Global Spanning Tree Parameters

This section includes instructions for using the BCC to configure global spanning

tree parameters.

Disabling and Reenabling Spanning Tree on the Router

To disable spanning tree on the router, navigate to the global span prompt and

enter:

state disabled

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 259 260

Sin comentarios

Avaya Configuring Bridging Services Manual de usuario Pagina 202