
Configuring IPv6 Services
3-28 118428-A Rev. A
Specifying a Remote IPv4 Address
If you are configuring an IPv4 static tunnel or an IPv4 semiautomatic tunnel, you
must supply a remote IPv4 address.
For a static tunnel and a semiautomatic tunnel, this address becomes the
destination address in the encapsulating IPv4 header.
You can use the following Site Manager procedure to perform this operation.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose Protocols.
The Protocols menu opens.
2. Choose IPv6. The IPv6 menu opens.
3. Choose Edit IPv6 Interfaces. The IPv6 Interfaces window opens.
4. Click on the interface you want to edit. Site Manager displays the parameter
values for that interface.
5. Set the Tunnel IPv4 Remote Address
parameter. Click on Help or see the
parameter description on page A-9.
6. Click on Apply, and then click on Done. Site Manager returns you to the
Configuration Manager window.
Comentarios a estos manuales