
Configuring IPv6 Services
4-12 118428-A Rev. A
Specifying the RIPv6 Diameter
The RIP diameter is a hop count that RIPv6 uses to denote infinity.
You must set this parameter so that none of the interface cost, static cost, or route
filter cost parameters exceed the RIP diameter. We recommend that you accept the
default RIP diameter value of 15.
You can use the following Site Manager procedure to perform this operation.
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
choose Protocols.
The Protocols menu opens.
2. Choose IPv6. The IPv6 menu opens.
3. Choose List RIP Interfaces. The IPv6 RIP Interfaces window opens.
4. Set the RIP Diameter parameter. Click on
Help or see the parameter description on
page A-26.
5. Click on Apply, and then click on Done. Site Manager returns you to the
Configuration Manager window.
Comentarios a estos manuales