Avaya Configuring BOOTP Services Manual de usuario descargar pdf (Pagina 28)

Configuring SNMP, BootP, and DHCP Services

1-8

308644-14.00 Rev 00

Starting a DHCP Server

You must use Site Manager to start a DHCP server.

Before you begin, you must do the following:

Verify that IP is configured on an interface, as described in “Configuring IP

for Global Protocols” on page 1-2.

Configure TCP on the router. For instructions on how to configure TCP on a

router, see Configuring IP Utilities.

Configure the NetID

Server Manager to communicate with the DHCP server.

For the DHCP server to operate, you must first install the NetID Server

Manager on a Windows NT

or UNIX workstation and configure it to

communicate with the DHCP server. Typically, you install the NetID Server

Manager on the same workstation as the one that contains the NetID database.

Because the DHCP server uses the information in the NetID database to

assign IP addresses and host configuration information, you need to set up

your network configuration using the NetID Management Console before the

DHCP server can operate correctly.

Using the NetID Management Console, you configure a DHCP server and

make IP addresses available for dynamic allocation. For more information

about installing the NetID Server Manager and setting your network

configuration using the NetID Management Console, see the NetID System

Administrator’s Guide.

To create and enable the DHCP server on the router, complete the following tasks:

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

choose

Protocols

The Protocols menu opens.

2. Choose

Global Protocols

. The Global Protocols menu opens.

3. Choose

DHCP

. The DHCP menu opens.

4. Choose

Create DHCP

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 173 174

Sin comentarios

Avaya Configuring BOOTP Services Manual de usuario Pagina 28