Avaya BCM 2.0 IP Telephony Manual de usuario Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 76
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
36 Engineering guidelines
Enterprise Edge 2.0 IP Telephony Configuration Guide P0911590 Issue 02
utilization. When received, the WAN link marks the H.323 flows as Premium
traffic and places the flows in the high priority queue.
Note: Differentiated Service (DiffServ) is a QoS framework standardized by
IETF.
In a non DiffServ or legacy network, the router manages the WAN link to make
sure Premium VoIP packets have high priority in both directions when crossing
a slow WAN link.
Implementing the network
LAN engineering
To minimize the number of router hops between the systems, connect the gateways
to the intranet, ensuring there is enough bandwidth on the WAN links shorter
routes. To prevent division of the constant bit-rate IP telephony traffic from bursty
LAN traffic, and make easier the end-to-end Quality of Service engineering for
packet delay, jitter, and packet loss, place the gateway and the LAN router near the
WAN backbone.
With supported codecs through the IP telephony network set to G.729, G.723.1 6.3
kbit/s, G.723.1 5.3 kbit/s, and G.711, ensure that up to 8 ports share the same
10BaseT LAN collision domain.
For the deployment of a mixed codec IP telephony, refer to Table 1 LAN and WAN
IP bandwidth usage per Enterprise Edge Gateway (loaded to 36 CCS per port per
hour) with silence compression on page 20 to estimate the amount of LAN
bandwidth used.
Setting the Quality of Service threshold for fallback routing
Configure the Quality of Service thresholds for fallback routing in the IP telephony
Manager application. Configure a threshold for both the receive fall back threshold
(Rx) and the transmit fall back threshold (Tx). The available thresholds are:
Excellent, Good, Fair, and Poor.
Table 8 Sample Mean Opinion Score to qualitative scale
Set the MOS values using the lowest number matching to the required threshold.
You can adjust the MOS values to fine tune the fallback scale.
MOS Range Qualitative Scale
4.86 to 5.00 Excellent
3.00 to 4.85 Good
2.00 to 2.99 Fair
1.00 to 1.99 Poor
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 75 76

Comentarios a estos manuales

Sin comentarios