Avaya ATM Link Modules and Routing Engines in BN Platforms Manual de usuario descargar pdf (Pagina 39)

Installing ARE Processor Modules

114951-B Rev 00

2-13

If you just installed the ARE processor module in a BLN or BLN-2

platform, replace the board retainer bracket:

Slide the top of the board retainer bracket into its designated ridge

and align the bottom of the bracket with the screw hole at the bottom

of the chassis (refer to Figure 2-5 or 2-6).

Using a screwdriver, secure the bracket to the chassis.

Replace the EMC shield as follows (refer to Figure 2-4):

Position the EMC shield in front of the chassis.

Tighten the captive thumbscrews that fasten the EMC shield to the

chassis.

Replace the front bezel as follows:

Align the mounting retainers on the inside of the bezel with the holes

on the front of the EMC shield.

Push the sides of the bezel into place.

Refer to Figure 2-1

(BLN), Figure 2-2 (BLN-2), or Figure 2-3 (BCN).

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 45 46

Sin comentarios

Avaya ATM Link Modules and Routing Engines in BN Platforms Manual de usuario Pagina 39