Avaya ATM Link Modules and Routing Engines in BN Platforms Manual de usuario Pagina 36

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 46
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 35
Installing ATM Link Modules and Routing Engines in BN Platforms
2-10
114951-B Rev 00
Removing the Board Retainer Bracket (BLN and BLN-2 Only)
If you have a BLN or BLN-2 platform, remove the board retainer bracket shown
earlier in Figure 2-5
(BLN) and Figure 2-6 (BLN-2):
1.
Use a screwdriver to remove the screw connecting the board retainer
bracket to the chassis.
2.
Gently pull the bottom of the board retainer bracket to remove it.
Removing an Air Flow Module
Nortel Networks ships an air flow module in each empty processor module slot in
the front of all BN platforms. Each air flow module redirects cool air to the
adjacent processor module.
Figure 2-8 shows the location of an air flow module. If the slot in which you want
to install the processor module contains an air flow module, you must first remove
the air flow module from that slot. If the slot you want to use already contains a
processor module, refer to the next section, Removing a Processor Module.
Figure 2-8. Air Flow Module in a BN Platform
Pull the front of the air flow module out to remove it (Figure 2-9.) Then proceed to
the section Inserting the Processor Module.
Board retainer bracket
(1 screw)
Air flow
module
POWER
RUN
BOOT
DIAG
BACKBONE NODE
VOR jeglicher Intervention Gerat
ABSTELLEN und Netzstecker herauszuziehen!
Anleitungen in Installations-/Instandhaltungshandbuch beachten!
VORSICHT!
HOCHSPANNUNG!
APAGUESE la unidad y desconectese del tomacrriente
ANTES de abrir la unidad.
Veanse las instrucciones del fabricante en el manual de instalacion/servicio
PELIGRO
ALTO TENSION
!
Power unit OFF and disconnect power cord
BEFORE accessing this product.
Refer to your installation/service manual for instructions
WARNING
HIGH ENERGY PRESENT
Debrancher le cordon dalimentation avant
denlever le couvercle.
Voir les instructions du fabricant
ATTENTION
EQUIPEMENT SOUS HAUTE TENSION
RESET
ALM0014A
Extractor
Vista de pagina 35
1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 45 46

Comentarios a estos manuales

Sin comentarios