Avaya ATM Link Modules and Routing Engines in BN Platforms Manual de usuario descargar pdf (Pagina 38)

Installing ATM Link Modules and Routing Engines in BN Platforms

2-12

114951-B Rev 00

Figure 2-10. Using the Extractors to Remove a Processor Module

Inserting the Processor Module

Insert the ARE processor module as follows:

Holding the board extractors open (refer to Figure 2-10), slide the

module into the card guides of the desired slot.

When inserting a module into a BLN or BLN-2 platform, lift the middle of the

board slightly and push it gently to ensure that the connector in the middle of

the board engages.

Swing the board extractors forward to lock the board in place.

If the extractors do not lock into place easily, remove the module and repeat

Steps 1 and 2.

When you insert the processor module into a slot, and the module determines

that slot power is stable, the module automatically

— Executes the diagnostics image on its memory card

— Completes the boot process

Observe the module and front-panel LEDs to determine whether it is

functioning properly.

Chapter 3 describes the ARE processor module LEDs.

Extractors

FRE0005A

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44 45 46

Sin comentarios

Avaya ATM Link Modules and Routing Engines in BN Platforms Manual de usuario Pagina 38