
Installing ARE Processor Modules
114951-B Rev 00
2-7
Choosing a Slot
You can install the ARE processor module in
• Slots 2 through 5 in the BLN platform (Figure 2-5)
• Slots 2 through 5 in the BLN-2 platform (Figure 2-6)
• Slots 1 through 6 and Slots 8 through 14 in the BCN platform (Figure 2-7)
Insert ARE processor modules only in slots opposite ARE link modules.
Figure 2-5. Location of Processor Modules and the SRM-F in a BLN Platform
Board retainer bracket
POWER
RUN
BOOT
DIAG
BACKBONE NODE
VOR jeglicher Intervention Gerat
ABSTELLEN und Netzstecker herauszuziehen!
Anleitungen in Installations-/Instandhaltungshandbuch beachten!
VORSICHT!
HOCHSPANNUNG!
APAGUESE la unidad y desconectese del tomacrriente
ANTES de abrir la unidad.
Veanse las instrucciones del fabricante en el manual de instalacion/servicio
PELIGRO
ALTO TENSION
!
Power unit OFF and disconnect power cord
BEFORE accessing this product.
Refer to your installation/service manual for instructions
WARNING
HIGH ENERGY PRESENT
Debrancher le cordon d’alimentation avant
d’enlever le couvercle.
Voir les instructions du fabricant
ATTENTION
EQUIPEMENT SOUS HAUTE TENSION
Extractor
SRM-F
(Slot 1)
RESET
FRE/FRE-2/ARE
processor modules
(Slots 2-5)
ALM0007A
Comentarios a estos manuales