Avaya Using Technician Interface Software Manual de usuario Pagina 106

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 382
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 105
Using Technician Interface Software
4-14 117381-A Rev. A
In-Band File Transfers
The tftp command invokes the Trivial File Transfer Protocol (TFTP) software to
transfer a file between a Bay Networks router and another router or host capable
of serving
tftp file transfer requests.
The TFTP software resides within the IP router. Consequently, you must load
TFTP on the router and enable it (see Quick-Starting Routers for instructions).
When you transfer a file to a Bay Networks router, unless you specify the target
volume, the TFTP server of the receiving (client) router uses the value of the
wfTftp.2.0 MIB attribute to determine the target volume.
For example, if you enter
tftp put 192.xx.x.xx 2:config
where 192.
xx.x.xx
is a valid IP address, the file config will be called config on the
router at the specified IP address and will go to the volume specified in
wfTftp.2.0. The same will happen if you enter
tftp put 192.xx.x.xx 2:config new_config
except that the file will be called new_config.
However, if you enter
tftp put 192.xx.x.xx 2:config 3:test_config
the file config will now be called test_config and reside on volume 3, overriding
whatever is in wfTftp.2.0.
The wfTftp.2.0 attribute is set during the Quick-Start procedure, using the
debug.al
alias setvol <slot no.> to target an NVFS volume or setvol 65 to target a
DOS volume.
Vista de pagina 105
1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 381 382

Comentarios a estos manuales

Sin comentarios