Avaya Using Technician Interface Software Manual de usuario descargar pdf (Pagina 69)

Using Operating Commands

308657-14.00 Rev 00

3-7

Enter the following to load a command into memory or unload a command from

memory:

exec [-load

-unload]

<command_name>

After you load a command into memory, it remains there until you issue an

exec -unload command, or until you restart the Technician Interface.

Using the Ping Command

Use the ping command to test the reachability of a remote device running the IP,

IPX, OSI, VINES, AppleTalk, or Advanced Peer-to-Peer Networking (APPN)

protocol. The implementation of ping is different for each protocol. The following

sections describe:

• The procedure the router uses to ping a remote device running a given

protocol

• The syntax of the

ping command for each protocol

• The possible messages displayed when you issue the

ping command

IP Ping

When you issue the ping command for IP, the ping program sends an Internet

Control Message Protocol (ICMP) echo request to the remote IP address you

specify. The remote device responds if it can be reached, and the console displays

the response or the result of the request.

Enter the following to ping a remote device running IP:

ping -ip

<IP_address>

[-t

] [-r

<repeat_count>

] [-s

<size>

] [-p]

[

-a

] [-v]

IP_address

> is the required IP address, in dotted-decimal notation, of the

remote device.

Note:

The

ping

command is not case-sensitive.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 343 344

Comentarios a estos manuales

Sin comentarios

Avaya Using Technician Interface Software Manual de usuario Pagina 69

Comentarios a estos manuales

Relacionado con productos y manuales para Software Avaya Using Technician Interface Software