
Configuring IP Utilities
5-2
304234-A Rev 00
Configuring TFTP Using the BCC or Site Manager
Table 5-1 lists the TFTP configuration tasks described in this chapter and
indicates whether you can use the BCC or Site Manager to perform each task.
Disabling and Reenabling TFTP Services
After you configure IP and start TFTP on the router, all TFTP default parameters
are automatically enabled on the router.
Using the BCC
To disable TFTP, navigate to the TFTP prompt and enter:
disable
For example, the following command line disables TFTP on the router.
tftp# disable
tftp#
To reenable TFTP, navigate to the TFTP prompt and enter:
enable
For example, the following command line reenables TFTP on the router.
tftp# enable
tftp#
Table 5-1. TFTP Configuration Tasks
Task BCC Site Manager
Disabling and Reenabling TFTP Services
✓✓
Specifying the Default Volume for the Router
✓✓
Specifying a Retry Timeout Value
✓✓
Specifying a Close Timeout Value
✓✓
Specifying the Number of Retransmissions
✓✓
Comentarios a estos manuales