
Configuring IP Global Access Policies
304234-A Rev 00
D-3
You are now in the context of the IP address for the policy. To return to the
policy-specify prompt, enter:
back
For example, the following command line returns you to the policy-specific
prompt:
network/policy_1/192.32.150.0/255.255.255.0#
back
access-policy/policy_1#
Disabling and Reenabling a Policy
By default, the access policy is enabled on the router.
To change the state of the global IP access policy you created, navigate to the
policy-specific prompt and enter:
state
<
state>
state
is:
enabled
(default)
disabled
For example, the following command disables policy policy_1:
access-policy/policy_1#
state disabled
access-policy/policy_1#
Specifying the Policy Action
By default, the policy denies access to the IP utility you specify (see “Specifying
the IP Service” on page D-4).
To specify whether the IP global access policy you created allows or denies access
to an IP utility, navigate to the policy-specific prompt and enter:
action
<
action>
action
is:
deny
(default)
allow
Comentarios a estos manuales