
Starting IP Services with Site Manager
303528-A Rev 00
3-9
Starting BGP
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as interface to an attached network. For information and
instructions, see Configuring WAN Line Services and Configuring Ethernet,
FDDI, and Token Ring Services.
When you have successfully configured the circuit, the Select Protocols window
opens. Proceed as follows:
Site Manager Procedure
You do this System responds
1. In the Select Protocols window, select the
following protocols:
•
IP
•
BGP
Then click on
OK
.
The IP Configuration window opens.
2. Set the following parameters:
•
IP Address
•
Subnet Mask
•
Transmit Bcast Addr
•
UnNumbered Assoc Address
Click on
Help
or see the parameter
descriptions beginning on page A-23.
3. Click on
OK
. The BGP Configuration window opens.
4. Set the following parameters:
•
Identifier
•
Local AS
Click on
Help
or see the parameter
descriptions beginning on page A-1.
5. Click on
OK
. The BGP Peer window opens.
6. Set the following parameters:
•
Peer Address
•
Peer AS
•
Local Address
Click on
Help
or see the parameter
descriptions beginning on page A-7.
7. Click on
OK
. Site Manager enables default BGP
service.
Comentarios a estos manuales