Avaya Configuring IP Services Manual de usuario Pagina 58

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 650
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 57
Configuring IP Services
3-4
303528-A Rev 00
Starting RIP
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as interface to an attached network. For information and
instructions, see Configuring WAN Line Services and Configuring Ethernet,
FDDI, and Token Ring Services.
When you have successfully configured the circuit, the Select Protocols window
opens. Proceed as follows:
Site Manager Procedure
You do this System responds
1. In the Select Protocols window, select the
following protocols:
IP
RIP
Then click on
OK
.
The IP Configuration window opens.
2. Set the following parameters:
IP Address
Subnet Mask
Transmit Bcast Addr
UnNumbered Assoc Address
Click on
Help
or see the parameter
descriptions beginning on page A-23.
3. Click on
OK
. You return to the Configuration Manager
window.
Vista de pagina 57
1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 649 650

Comentarios a estos manuales

Sin comentarios