Avaya Configuring Frame Relay Services Manual de usuario descargar pdf (Pagina 39)

3-1

Chapter 3

Enabling Frame Relay

This chapter describes how to enable Frame Relay. It assumes you have read

Conﬁguring Routers or Conﬁguring Customer Access and Trunks (BNX

Software), depending on the type of installed software that you have

1. Opened a conﬁguration ﬁle

2. Speciﬁed router hardware if this is a local mode conﬁguration ﬁle

3. Selected the link or net module connector on which you are enabling Frame

Relay

When you enable Frame Relay service, you do not have to conﬁgure any Frame

Relay parameters. The Conﬁguration Manager supplies default values for all

Frame Relay parameters. To edit these default values, refer to Chapter 4.

Enabling Frame Relay on an Interface

To enable Frame Relay on an interface, complete the following steps:

1. From the Conﬁguration Manager window, select a link or net module

connector that requires a WAN circuit (Figure 3-1).

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 83 84

Sin comentarios

Avaya Configuring Frame Relay Services Manual de usuario Pagina 39