Avaya Configuring BayStack Remote Access Manual de usuario Pagina 78

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 140
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 77
Configuring BayStack Remote Access
4-10
308614-14.00 Rev 00
Verifying Your Configuration
You can use the
getcfg
command to verify the following:
Whether the router is set to boot using a local or remote boot image
Whether the router is set to configure using a local or remote configuration
file
The configuration of the serial, Ethernet, and token ring (ARN only)
interfaces
To display the configured startup options for a BayStack router, enter the
following command at the Technician Interface or AN Monitor prompt:
getcfg
The following sample output shows the default configuration for an AN/ANH
with one Ethernet interface and two serial interfaces:
Boot Options
boot image=local
boot config=network
Netboot Parameters:
XCVR1..None
COM1...EZ-Install
COM2...EZ-Install
The following sample output shows the configuration for an ARN with one
Ethernet interface, one token ring interface, and five serial interfaces:
Boot Options
boot image=local
boot config=network
Netboot Parameters:
MAU1...None
XCVR2..None
COM1...EZ-Install
COM2...EZ-Install
COM3...EZ-Install
COM4...EZ-Install
COM5...EZ-Install
Vista de pagina 77
1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 139 140

Comentarios a estos manuales

Sin comentarios