Avaya Configuring BayStack Remote Access Manual de usuario descargar pdf (Pagina 76)

Configuring BayStack Remote Access

4-8

308614-14.00 Rev 00

Configuring an ARN Token Ring Interface for Network Booting

To configure an ARN token ring interface for network booting, enter the following

command at the Technician Interface or AN Monitor prompt:

ifconfig

[

-d

] [

-r

speed

[

<IP_address> <subnet_mask>

[

<next_hop_address>

]]

Table 4-4 describes the

ifconfig

command options for configuring the ARN’s

token ring interface.

Note:

The token ring interface must be configured with IP to support netboot

options.

Table 4-4. ifconfig Command Options for an ARN Token Ring Interface

Option Description

-d

Resets the ARN’s IP interface options to the default values. Resetting

a token ring interface makes it inactive in the network booting process.

(The output of the

getcfg

command shows the default as None.)

-r

<speed>

Specifies the speed of the token ring interface. Specify either

(Mb/s). The default is 16 Mb/s.

Specifies the IP connector you are configuring. Use the format

mau

<port_no.>

<IP_address>

Specifies the IP address of the interface you set with

Provide this address in dotted-decimal notation.

<subnet_mask>

Specifies the IP subnet mask of the interface you set with

Provide this address in dotted-decimal notation.

<next_hop_

address>

Specifies the IP address of the next-hop router. Provide this address in

dotted-decimal notation. Specify this address only if there are

intermediate routers between the ARN and the BootP server.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 139 140

Comentarios a estos manuales

Sin comentarios

Avaya Configuring BayStack Remote Access Manual de usuario Pagina 76

Comentarios a estos manuales

Relacionado con productos y manuales para Routers Avaya Configuring BayStack Remote Access