Avaya Configuring BayStack Remote Access Manual de usuario descargar pdf (Pagina 32)

Configuring BayStack Remote Access

1-14

308614-14.00 Rev 00

EZ-Install

EZ-Install is the easiest option for the person at the BayStack router site to

perform, because the BayStack router automatically begins the procedure at

startup, and the network automatically supplies the IP address and configuration

file.

The EZ-Install procedure requires the following at initial startup:

• A communications link between the BayStack router and an upstream router

over an HDLC or frame relay interface

• A BootP server that contains a customized configuration file for the BayStack

router

If EZ-Install fails in an initial startup attempt, one of the following occurs:

• An AN or ANH router attempts to boot once using the Local Boot option. If

both boot attempts fail, you must troubleshoot the problem and reboot the

router as described in Appendix B.

• An ARN router first tries to local boot, and then tries to netboot. The ARN

continuously attempts to local boot and netboot until it boots successfully, you

turn off the ARN, or you interrupt the process in one of the following ways:

-- Press the Reset button on the ARN back panel

-- Type the [Control]-c break sequence at the management console

Local Boot

The Local Boot procedure requires the following at initial startup:

• An installed PCMCIA flash memory card that contains the software image

file and a generic configuration file

• A local console or modem connection with the BayStack router

When you use Local Boot as the initial boot option, the Site Manager connection

is not yet in place. The BayStack router boots using the generic configuration file;

then, you must run the Quick-Start installation script to customize the

configuration file and save it locally (see Figure 1-6

on page 1-12).

See the description of the Quick-Start installation procedure in Appendix C.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 139 140

Sin comentarios

Avaya Configuring BayStack Remote Access Manual de usuario Pagina 32