Avaya Configuring IP Multicasting Services Manual de usuario Pagina 86

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 126
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 85
Configuring IP Multicasting Services
6-10 114064 Rev. B
Specifying the Unreserved Queue Length
If the Unreserved Policing Algorithm parameter is set to Queue Limit, you can
specify the maximum number of unreserved (best-effort) packets to be held in
queue for transmission. After the queue length reaches this value, the router
discards best-effort traffic when congestion occurs.
Note that Priority queuing limits, if configured, override the value of this
parameter.
By default, the Resource Manager holds a maximum of 20 unreserved packets in
queue for transmission. Change this value to adjust the queue length limit, a value
from 0 to 214748364 packets (limited by available buffers).
Specifying the Multiline Select Algorithm
If you configured the Resource Manager on a multiline circuit, you can choose
one of two algorithms that determine how the Resource Manager selects which
line to use for a new resource request:
First Fit -- Always uses the first available line that can service reserved traffic
requests
Round Robin -- Rotates the use of lines available to service requests
All lines for a circuit must use the same algorithm. If any one line on a circuit
specifies First Fit, all lines use the first-fit algorithm.
Setting the Multiline Threshold Bandwidth
When using the First Fit Multiline Select Algorithm (see the previous section,
Specifying the Multiline Select
Algorithm”), you can configure a threshold of 0
to 214748364 b/s for the first available line.
Site Manager: Unreserved Queue Length parameter: page A-30
Site Manager: Multiline Select Algorithm parameter: page A-31
Vista de pagina 85
1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 125 126

Comentarios a estos manuales

Sin comentarios