Avaya BCM 2.0 Programming Guía de usuario descargar pdf (Pagina 66)

66 Configuring Enterprise Edge Resources

Enterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01

V.90 Modem Access Parameters

1. Use the following table to set the V.90 Modem Access Parameters:

2. Press the TAB key to save the settings.

Guidelines for Using Remote Dial-in

Consider the following guidelines when using remote dial-in:

• The same modem is shared between the remote dial-in for administration and

the backup WAN link. If a remote administration user is connected while the

primary link breaks, the automatic backup function does not occur.

• While using the back-up interface, Enterprise Edge always calls. Enterprise

Edge does not answer an incoming call from a router.

Media Services Card

Enterprise Edge applications consume Digital Signal Processor (DSP) resources.

DSP resources are controlled by software (the number of ports or services that are

available to any application)and hardware(the number ofMSPECs)installed. Each

system is preconfigured with a default DSP resource allocation based on the

number of MSPECs installed. However, you may need to change the DSP resource

allocation using the DSP Manager if you:

• replace an MSPEC

• purchase more software

For more information on configuring DSP resource allocation, refer to:

• Rules for configuring DSP resource allocation on page 67

• DSP Current Configuration on page 68

• DSP Manager on page 68

• DSP Settings on page 69

Attribute Description

Authentication Lets you select the authentication type for the link. The options are

AllowClearText or EncryptedOnly.

AllowClearText: when selected the Challenge Handshake

Authentication Protocol (CHAP) is used first and if the receiving end

of the link declines, PAP is used to authenticate the link.

EncryptedOnly: when selected, only encrypted authentication such

as CHAP is used on this interface during PPP authentication process.

Two Way Authentication Lets you enable or disable link authentication in both directions.

User ID (name password) Lets you define a user name and a password that the link uses to

authenticate itself when dialing out to another router.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 445 446

Sin comentarios

Avaya BCM 2.0 Programming Guía de usuario Pagina 66