Avaya BCM 2.0 Programming Guía de usuario Pagina 300

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 446
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 299
300 Maintenance
Enterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01
4. Choose the type of alarm you wish to view. For example, LOS (Loss Of
Signal).
5. ClickonthePeriod #.
The display shows the Start time of the period.
Check bipolar violations
1. Choose Diagnostics, Trunk Modules.
2. Choose a bus and then choose a module.
3. Choose CSU Statistics andclickontheAlarm statistics heading.
The display shows the number of bipolar violations that occurred in the last
minute.
Check short term alarms
1. Choose Diagnostics, Trunk Modules.
2. Choose a bus and then choose a module.
3. Choose CSU Statistics, Alarm statistics,andclickontheShortTerm
alarms heading.
The display shows the short term alarms and the number of milliseconds (not
necessarily contiguous) that were active in the last minute.
Check Defects
1. Choose Diagnostics, Trunk Modules.
2. Choose a bus and then choose a module.
3. Choose CSU Statistics, Alarm statistics,andclickontheDefects heading.
The display shows the first type of defect and the number of milliseconds (not
necessarily contiguous) the hardware reported in the last minute.
Reset all statistics
1. Choose Diagnostics, Trunk Modules.
2. Choose a bus and then choose a module.
3. ClickontheCSU Statistics heading.
4. On the Configuration menu, click Clear CSU statistics.
The system displays a message indicating that this will remove all of the
statistics.
Vista de pagina 299
1 2 ... 295 296 297 298 299 300 301 302 303 304 305 ... 445 446

Comentarios a estos manuales

Sin comentarios