
154 Configuring Enterprise Edge Services
Enterprise Edge 2.0 Programming Operations Guide P0911588 Issue 01
CAP assignment
The CAP assignment setting designates a telephone as a central answering position
(CAP). The CAP must be an M7324 telephone, and may have one or two CAP
modules attached. You can install a maximum of five CAPs on Enterprise Edge.
The CAP can:
• Monitor the busy/not busy and Do not disturb status of Enterprise Edge
telephones.
• Answer external calls on up to 120 lines, and extend calls to other Enterprise
Edge telephones.
• Send up to 30 messages to other Enterprise Edge telephones.
• Provide up to 96 extra memory buttons for the M7324 telephone.
To configure a CAP assignment:
1. Choose Services, Telephony Services, General Settings, CAP assignment.
2. Click on the CAP you want to program (CAP 1-CAP 5). The CAP # window
appears.
3. Type the set number of the M7324 telephone you want to designate as a CAP.
Dialing plan
Dialing timeout
Dialing timeout specifies how long Enterprise Edge will wait between user-dialed
digits. This value allows Enterprise Edge to determine when the user has stopped
dialing.
The user can also use the ‘#’ key to tell Enterprise Edge that they are finished
dialing however, this is not usually required except for international calls where the
number of digits dialed varies.
1. Click on Dialing plan. The Dialing plan window appears.
2. In the Dialing timeout box select a timeout value. You can select the
following values (in seconds): 3, 4, 5, 6, 8, 10, 15.
Tips
If CAP modules are attached to an M7324 telephone that has not been
programmed as a CAP, then no CAP settings are assigned. If a CAP module
(or modules) is relocated with the M7324 telephone, the settings are retained.
Comentarios a estos manuales