Avaya Sync/Ethernet Link Modules in BN Platforms Manual de usuario Pagina 45

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 58
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 44
Checking Status Indicators
114948-A Rev. A 3-3
Table 3-2. Functions of the Ethernet LEDs
LED Function
COL Indicates a collision detection.
RCVR1 or RCVR2 Indicates that the respective port is receiving data.
XCVR1 or XCVR2 Indicates the presence of Ethernet traffic (either transmitting or
receiving) on the respective port.
FAIL Indicates one of the following:
Diagnostic testing is in progress. Diagnostic testing occurs when
you cold-start the module. You cold-start the module when you
cycle power, issue the diags command from the Technician
Interface, or hot-swap the link module. This LED blinks three
times and goes out when the diagnostic testing terminates
successfully.
Power-up diagnostic testing failed and the link module is waiting
for an automatic attempt to reinitiate diagnostic testing. If the FAIL
LED turns on again, call the Bay Networks Technical Response
Center.
A link module hardware problem exists and the link module is
waiting for an automatic attempt to reinitiate diagnostic testing. If
the FAIL LED turns on again, call the Bay Networks Technical
Response Center.
Vista de pagina 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 57 58

Comentarios a estos manuales

Sin comentarios