Avaya Sync/Ethernet Link Modules in BN Platforms Manual de usuario Pagina 44

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 58
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 43
Installing Sync/Ethernet Link Modules in BN Platforms
3-2 114948-A Rev. A
Figure 3-1. Sync/Ethernet LEDs
Table 3-1. Functions of the Synchronous LEDs
LED Function
RLSD1, COM1
or COM2
Indicates Carrier Detect is present on the respective port.
FAIL Indicates one of the following conditions:
Diagnostic testing is in progress. Diagnostic testing occurs when you cold-start the
module. You cold-start the module when you cycle power, issue the diags command
from the Technician Interface, or hot-swap the link module. This LED blinks three
times and turns off when the diagnostic testing terminates successfully.
Power-up diagnostic testing failed and the link module is waiting for an automatic
attempt to reinitiate diagnostic testing. If the FAIL LED turns on again, call the Bay
Networks Technical Response Center.
A catastrophic failure due to a hardware problem on the link module occurred and
the link module is waiting for an automatic attempt to reinitiate diagnostic testing. If
the FAIL LED turns on again, call the Bay Networks Technical Response Center.
XCVR
SSE
RCVR1
FAIL
COM 1
RLSD1
5410
FAIL
XCVR
COM2
DSE
RCVR1
COM 1
RLSD1
5420
COL
XCVR
COM1
DSDE
5430
RCVR1
FAIL
COM˚2
XCVR2
RLSD1
COM 2
XCUR1
FAIL
RCUR2
RCUR1
DSDE
COM1
XCUR2
5530
RLSD1
ESAF-4
XCVR1
XCVR2
COM 1
COM 2
SEN0007A
Vista de pagina 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 57 58

Comentarios a estos manuales

Sin comentarios