Avaya Sync/Ethernet Link Modules in BN Platforms Manual de usuario descargar pdf (Pagina 41)

114948-A Rev. A 2-1

Chapter 2

Installing the Link Module

Complete the steps in this chapter to install the Sync/Ethernet link module in your

BLN, BLN-2, or BCN platform.

Inserting the Link Module

Install the link module in the BLN, BLN-2, or BCN platform as follows:

1. Attach an antistatic wrist strap.

BN platforms and link modules ship with an antistatic wrist strap. You must

wear one of these straps whenever you access components in a platform.

The antistatic wrist strap directs the discharge of static electricity from your

body to the chassis, thereby avoiding discharge and possible damage to

sensitive electronic components.

2. Slide the module into the appropriate slot, using the slot card guides.

Refer to Figure 1-1 (BLN), 1-2 (BLN-2), or 1-3 (BCN) for slot locations.

3. Insert the module until its connector panel touches the router back panel.

4. Secure the captive screw on each end of the module (Figure 2-1).

Figure

2-1 shows the captive screws on a Single Sync/Single Ethernet link

module; these screws are the same on all link modules.

Caution: Electrostatic discharge can damage hardware. Always use the

antistatic wrist strap when handling any router components.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 57 58

Sin comentarios

Avaya Sync/Ethernet Link Modules in BN Platforms Manual de usuario Pagina 41