
Installing Sync/Ethernet Link Modules in BN Platforms
1-10 114948-A Rev. A
*. These jumpers determine the output voltage levels on the unbalanced driver devices. We
recommend that you leave the jumpers in the ±12V position for correct unbalanced operation.
† When configuring for V.35, place the S11 jumpers (A through E) in the unbalanced position to
support V.35/V.28 control signals.
Installation of V.35
daughterboard
V.35 daughterboard not
installed
V.35 daughterboard installed
Table 1-2. Dual Sync/Single Ethernet Jumper Settings
(continued)
Option Setting Jumper
Comentarios a estos manuales