Avaya Sync/Ethernet Link Modules in BN Platforms Manual de usuario Pagina 43

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 58
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 42
114948-A Rev. A 3-1
Chapter 3
Checking Status Indicators
This chapter describes the status indicator lights (LEDs) on the Sync/Ethernet link
modules. Use the LEDs to verify that the link module is operating after
installation.
Figure
3-1 shows the LEDs on the Sync/Ethernet link modules. Table 3-1
describes the Sync LED functions and T
able 3-2 describes the Ethernet LED
functions.
Note: We recommend that you issue the diags command to the associated
slot, using the Bay Networks Technician Interface, immediately after you
insert a link module. (Refer to Using Technician Interface Software if you use
router software or Troubleshooting and Testing if you use BayStream
software.) Otherwise, the link module FAIL LED will remain lit, indicating
that diagnostics have not run on the Intelligent Link Interface (ILI). However,
even if you do not issue the
diags command, the link module initializes and
becomes operational as long as the board functions properly and contains the
correct interface configurations.
Vista de pagina 42
1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 57 58

Comentarios a estos manuales

Sin comentarios