Avaya Administering Aura Session Manager Release 6.1 Manual de usuario descargar pdf (Pagina 334)

Adding a SIP entity as a Session Manager instance

Before you begin

Before starting this procedure, make sure that the SIP entity that you want to add was created.

For a Session Manager SIP Entity type, you must administer the listen ports on the SIP entity

form. These listen ports are used by endpoints to connect to Session Manager and can be

used to map different ports to different domains.

Procedure

1. On the System Manager console, under Elements, click Session Manager.

2. Click Session Manager Administration in the left navigation pane.

3. On the Session Manager Administration page under Session Manager Instances,

click New.

4. Under the General section, enter the following information:

a. Select the SIP Entity Name from the drop-down list.

b. In the Description field, add a description for this entity.

c. In the Management Access Point Host Name/IP field, enter the IP address

of the management interface (eth0) of the Session Manager server.

d. Select the Direct Routing to Endpoints from the drop-down list.

e. For Adaptation for Trunk Gateway, select None from the drop-down list.

5. Under the Security Module section, enter the following information to configure the

Security Module:

a. In the Network Mask field, enter the value for the network mask associated

with the network that the Security Module network interface will be connected

to.

b. In the Default Gateway field, add the IP address of the default gateway.

c. In the Call Control PHB field, use the default value of 46 (forward with highest

priority).

d. In the QOS Priority field, enter a 802.1q priority value. The default is 6.

e. In the Speed & Duplex field, select a value from the drop-down menu to

configure the security module interface speed and duplex values.

f. In the VLAN ID field, enter an integer value. This is the VLAN that the Session

Manager is to be associated with. Leave this field blank if VLANs are not in

use.

SIP Entity IP Address field is populated as per the IP address of the SIP entity.

6. Under the NIC Bonding section, enable or disable NIC bonding by selecting or

clearing the Enable Bonding check box.

7. Under the NIC Bonding section, select a monitoring mode for NIC bonding from

the drop-down menu for Device Monitoring Mode

Configuring and monitoring Session Manager instances

334 Administering Avaya Aura

Session Manager November 2010

1 2 ... 329 330 331 332 333 334 335 336 337 338 339 ... 531 532

Sin comentarios

Avaya Administering Aura Session Manager Release 6.1 Manual de usuario Pagina 334