
Configuring IP Multicasting and Multimedia Services
A-14 117355-A Rev. A
Parameter: Report Depend Probe
Path: Configuration Manager > Protocols > IP > Multicast > DVMRP > tunnel
Default: Disable
Options: Enable
| Disable
Function: Specifies the conditions under which DVMRP accepts a route report.
According to the protocol, DVMRP must send a probe packet before sending
the route report packet to its neighbors. Some vendor implementations,
however, do not send probes before sending reports.
Instructions: By default, DVMRP processes all received route reports. Enable this feature if
you want DVMRP to process only routes received from neighbors that have
sent probe packets in accordance with the protocol.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.12.3.1.28
Parameter: Local IP Address
Path: Configuration Manager > Protocols > IP > Multicast > DVMRP > Tunnel >
Click on Add
Default: Null
Options: The unicast IP address of an interface on a circuit supporting multicasting on the
local router
Function: Identifies the local end of the tunnel. To identify a unicast tunnel, you must
supply the unicast IP address of both ends of the tunnel: the local interface and
the remote interface.
Instructions: Use this parameter to enter the local IP address.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.12.3.1.4
Comentarios a estos manuales